HP Forums

Full Version: Re: HP-29C: another faulty calculator through eBay...
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Dancing and flashing digits is NOT a typical ACT symptom. I've seen many 29C's with this problem. Most likely cause is a bad filter capacitor in the DC-DC converter inside the calculator.

Does anyone have any info about what Bram said below (harming the calc when using regular AA batteries)?

It may have been a message in this forum; I cannot remember quite right.

On the other hand, here someone shares my experience that it didn't harm. As long as I haven't read a proof that the voltage difference between NiCds and alkalines (0.6 V) can or cannot harm, I don't take the risk (anymore).
It looks like you shouldn't worry about having applied alkalines though.

Bram,
I didn't understand. Did the alkalines have to be connected on one end as well? I am not sure how that solution worked. Can you please clarify?
Thanks,
Andreas

since we are talking about series 2x calculators, here is a picture of the battery pack of my HP-21:

you can see the two alcaline batteries. They are linked on the rear by the existing springs in the HP-21 pack. I had to remove the plastic strip on the top of the pack to allow easy access to the batteries.

**vp

Thank you, Vassilis. Clear picture.

I did exactly the same thing: remove the middle bar, take out the NiCd cells (little force needed) and put 2 alkalines back in. If you use the calculator often and frequently replace the batteries it may be handy to write big pluses and minuses at all proper places in the compartment, and fix the spring with a little piece of tape with 2 sticky sides ('double fix' as it is called in NL).

I have the impression that alkalines are a bit longer and often have a smaller "head". This may cause more tension to the circuit board, so I always put the pack in the calc very carefully.

But, as said before, I hold on to the safe NiCds nowadays.