HP Forums

Full Version: Dust on HP-42S Window
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Can anyone tell me how to remove (or move) the dust on the inside surfaces of my HP-42S display window(s)?

Thanks,
Tom Scott

CHECK OUT RANDY'S POST BELOW:

http://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/archv013.cgi?read=41672

Thanks. I don't know how I missed that.

Tom Scott

One thing I failed to mention was not to jam the tube in so far as to split the bottom half from the top. The older windowed version machine bezels will distort a bit, possibly leaving a wrinkle. Uggh. You just need to direct the air blast between the halves and the tapered tip helps alot.

Edited: 12 Sept 2003, 8:24 p.m.

The techique worked pretty well although I did leave small marks on the side of the plastic case where I wedged the two halves apart. Also, it looks like I left a small mark on the window (perhaps when I slipped trying to wedge the tube in).

Tom Scott