HP Forums

Full Version: batteries
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Hi Guys.
What is the best way to clean up the salts from the NiCads?
Should special precautions be taken?

I have several NiCads that continue to function with some corrosion/ salts. Should I continue to use these batts?

Robert wrote:
> I have several NiCads that continue to function with some
> corrosion/ salts. Should I continue to use these batts?

My advice is to throw them away.

**vp

The compounds from a Ni-Cad are generally water soluble. In areas where it's safe to use water, just use warm water. On plastics I wouldn't use water any warmer than I could put my finger in.

If you are getting into the elecgtronics it's dicier. It's possible to wash with water but requires careful rinsing and drying techniques and runs the risk of the water carrying salts to areas further away where you don't want them if you haven't controlled the washing and rinsing well enough.

PS. If you must use a leaking Ni-Cad, get a 99 cent flaslight to use it in.


Edited: 28 Aug 2003, 11:16 a.m.

I'll agree, throw them away. And to clean the terminals I use 1/2 lemmon juice with one tea spoon of salt (NaCl), this cleans the copper oxide.

Regards,

Nelson

Don't throw them away; recycle them. Since NiCad's contain Cadmium, they are considered toxic waste and can damage the environment. Besides, it is illegal to throw them away.

To find a place where you can recycle them, see http://www.rbrc.org.

The electrolyte in NiCd cells is alkaline (it used to be potassium hydroxide IIRC, no idea what it is now). So you want a (chemically) weak acid to clean it up.
I normally use a dilute solution of citric acid, which seems to clean battery contacts, cases, etc with no further damage.

One usually winds up with mostly potassium carbonate as the offending white powder. Cleans up well with vinegar, water, or isopropyl alcohol.