HP Forums

Full Version: HP-41 module covers and side port cover
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

While repairing an old HP-41, I needed to create 3D models for the side port and module port covers. I have upload these models to:

Test prints on my 3d printer worked well in ABS plastic. I am also working on a battery holder/cover, but it is currently about 1/10 of an inch too wide; once it is correct I will also upload that file

Hello Nate,
Good job! How does the printed pieces looks like?


From the cappuccino state