11-09-2013, 06:13 PM
11-10-2013, 03:14 AM
Most probably one menuitem returns the command for a single intersection point (single_inter), the other one a list of intersection points (inter).
11-10-2013, 07:52 AM
1.
Sorry, but when i construct to lines with one intersection point, an choose "Point -> Intersection" and choose one after another line then it constructs no intersection point . Where i have made an mistake? Can you describe me the procedure (not mentioned in manual).
2.
When i construct the midpoint C between to points A and B then the "Enter"-key normally show me the list of points for choosing. But in this list there are only the point A and B. But not the point C. Why?