HP Forums

Full Version: Voyager Self Test
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

One of the self tests for Voyagers (HP-10C, -11C, 12C, -15C, and -16C) is for key board and display segments. It is startet with the calculator off by pressing the '/' key (upper left corner), hitting the ON key (lower left corner) and then releasing the '/' key. The display shows four segments "lit" (well, they are black or visible). To pass the test you must hit now all keys _once_ in sequence (only the ENTER twice, just in "it's" row), going row by row beginning with the upper left key. At every key press the display changes, showing four segments in the first row and all but the last key only two segments.

Question to all with access to a real HP-10C _and_ other Voyagers: comparing the display step for step, are the same segments lit on both Voyagers?

Questions to the experts: are there differences within the Voyager series regarding the display? Yes there are, but is there more out there than Erig's highly valuable variants list, especially about the display? A manual about the Voyager's self tests could help I assume. One more: are there ROM revisions?

TIA for all your effort

On go1xc emulators there could be some artifacts when doing the test : on go15c for the key '2' the display is mistaken as a program line and display -GTO ,0 :)

Perhaps I should also correct this too ?

Olivier

The "real" 10C has a different key test display sequence than the "real" 11C/12C/15C/16C. However it works the same way, 4 segments for each key press on the top row, 2 segments for each other key press.

Quote:
Questions to the experts: are there differences within the Voyager series regarding the display? Yes there are, but is there more out there than Erig's highly valuable variants list, especially about the display? A manual about the Voyager's self tests could help I assume

Eric mentions this in his document:

Quote:
Most recently, the HP-12C was redesigned to run from a single coin cell rather than three button cells. (All other Voyager calculators had since been discontinued.) The chip was redesigned again as the 2AF1-0001 in order to operate at the lower voltage. The LCD was probably also changed; it might still have the same organization and contacts, but likely contains a different liquid crystal material optimized for the lower voltage.

There are only slight differences in LCD voltages (~ 500mv) in spite of the supply difference of 1.5 volts. I can tell you from display repairs I've done that the 3 volt 12C displays do in fact work in the older one chip version 11C's and the two chip 15C's. Other than the change in the reflector color from silver to gold, they appear to work without any visible differences.

Quote:
One more: are there ROM revisions?

Hopefully Eric will respond to that one. I don't think there are but if anyone knows, it will be him.

Edited: 16 May 2013, 1:48 p.m.

Thank you for your time (and batteries)

Ciao.....Mike

Thank you for the details. I am at most interested in differences in 'organisation' of the switching of single display segments. Those, which could require a change of the firmware.

Ciao.....Mike