HP Forums

Title says it all. Tony mentioned that I should use the "smallest" kit, but I don't know what that is.

For example, this kit:

3M 7622 Cold Shrink Wrap Kit 7622-T-110

...is shown as:

insulation OD 0.64" to 1.08"

...but I don't know if that would fit.

I think that is much too large. It needs to fit on the metal spindle from the original platen, which IIRC is about 1/4" in diameter.

I think the kit I used as 3M 8424-8. If you send me an e-mail (ard@p850ug1.demon.co.uk), I'll send you some more information.