Greetings all.
Any recommendations as to the best glue for sticking the battery holder used in the Woodstocks together? I've just acquired an HP25C where the battery holder sides have become detached from the solid part (ie that bit which forms the bottom of the actual calculator when the battery holder is in place) and remedial action is required.
TIA
James
Plastic welding solvent cement for styrene models. Available at any good hobby shop.
Superglue works very well and you don't need a lot of it. Just apply a drop at about 1 cm intervals, and then immediately press the two parts together for about 30 seconds. Clean both contacting surfaces thoroughly first and remove any burrs or loose bits of plastic.
I have used liquid plastic cement and clamps.
1. clean up the edges
2. rough up the surfaces that are to be glued with 400 grit
sandpaper
3. apply glue to both sides and then place pieces together
4. clamp until dry, give it an hour or so
This will give a permanent bond to the woodstock battery pack.
Cheers, Geoff
Many thanks for the advice everyone.
Cheers
James